• ×   You have pasted content with formatting.   Remove formatting

  • Recently Browsing   0 members

  • Similar Content

    • Duracraft roof fit issues (Linfield)
      By JSundbakken
      I am constructing the Duracraft linfield and I’m dry fitting the roof, but it’s just not fitting right. Do they ever? Should I sand and try to figure it out or glue and fill in with wood putty? I have done everything correct with the instructions, so I don’t know what’s best to do. Any suggestions?

    • help to Identify these from mixed lot of minis
      By fleabags3
      I bought a lg box of minis and wanted some help identifying these- age etc if possible .  Thank you in advance! 



    • Dura-Craft Newberg Help
      By Stacy Nicole
      Hello,
      I stumbled upon a Newberg at a local thrift shop for $3 the other day & obviously couldn't pass bringing it home. It was spray painted pink, had glitter glue adorning the exterior window casings & the roof was a lovely sponge painted gold & purple -- OOF. Anyhow, I've repainted the exterior to mimic local Victorian home I'm in love with, but wanted to reach out for some suggestions to replace the missing trimmings for the arched window frames. Reframing the square frames was easy enough, I just used some bass wood from the craft shop, but for the curved frames I'm at a standstill. Would you suggest cardstock or mat board? I supposed  I could cut them all from wood, but it would be pricey & I'd likely ruin quite a few in the process. 
       
      I'd also love some suggestions to add back the lovely gingerbread work to the window panes. I was thinking just adding the designs to some clear plastic with a paint pen...I've attached the house as it stands currently. 

    • Help with Trunk Kit
      By Test
      I picked up a dollhouse trunk kit from an estate sale and thought it would be the perfect accessory for my most recent house building project.  However, while all of the pieces/components were there, the kit was missing the critical instructions.  I thought it would be a cinch since, after all, it was only a basic trunk, but when I poured out the contents there seemed to be a few more pieces than what was represented in the only drawing that was included.
      First off, just based on the picture (there was no manufacturer information included) can anyone identify this kit?  Secondly, I am pretty since the inside is intended to be papered, that this is a fully functioning, hinged, trunk and that the additional pieces are a part of that mechanism, but I am unsure of how to proceed.  Can anyone advise based on the picture?  I will do my best to describe the pieces:
      The kit came with:
      Wooden pieces to assemble top and bottom of trunk (done) Brass findings for the top and sides of trunk (done) Brass latch for the front of trunk (done)--all placed based on picture The parts I am uncertain of:
      4 brass half circles--I am assuming that these represent the back hinges, but am not sure if they belong visible on the back or on the inside back of the trunk when open 2 small brass medallions (they are cupped as seen in second picture).  Each of the medallions has a small hole on one end 2 small brass wires that came pre-bent--I experimented with these and they pass easily through the hole in the medallions without going all the way through 2 small brass hoops that slightly thin at the joint 1, approx 1.5" brass wire 1 piece yellow satin ribbon