4 posts in this topic
Recently Browsing 0 members
Very first dollhouse - Advice please
Hello everyone. I just bought my first dollhouse (The Orchid) and I'm excited but rather nervous to start it. I want to make sure I do everything right, so I'm asking for your tips & tricks for starting out. I've looked around the site a bit, but there's so many posts here it's kind of over-whelming. Any advice would be greatly appreciated.
Any window construction experience?
I'm now on to my third dollhouse, and unlike the first two which were purchased kits, this doll house is a rescue!! Found on a street curb, it was really in pretty good shape. The original builder did a good job constructing the house; the shingles are a lesson in perfection; the painting and wallpaper show a better than average understanding of how to handle these tasks; floorings were in good shape and installed with double sided tape. Yes, there are a few loose shingles, the door is broken along with the porch. Biggest problem is the outside wall are dado cuts to mimic siding and the builder reversed the front and glued the siding side inside rather than outside. That will be easily remedied with Greenleaf siding strips. This will soon be the Farmhouse I envision.
But I desperately want to replace the windows. The large front windows are a bit smaller than standard size--I'll enlarge opening to accept new windows. However, the dormer windows are rectangular rather than square and an irregular size. I have not been able to identify the dollhouse, so there is no chance of finding manufacturer to see if there is a more current window style available. I am now faced with going where I haven't gone before and building my own windows.
Any suggestions or words of advice out there?
How To Install Windows
I purchased an almost completely built Glencroft dollhouse at an estate sale. The only things left to do are the windows and doors. No directions came with the house. I have looked at a lot of pictures online but I simply can't figure out how to do the windows. Can anyone help me? Thanks in advance.
Here is a picture of the clip on earring back light bulb & shade holder for Miranda (SewMini).
Jewelry pin through the middle hole. Light bulb wire through any of the others. The shade fits snugly onto the earring back, holding it in place.
The holes in the earring back allow light to come out of the bottom of the lamp as well as the top.