Hummingbird shower completed
I added the shower head and water control lever from ELF Miniatures. I used a simple washer to serve as an escutcheon for the water control lever. I added lines of red and blue paint to indicate the hot-cold adjustment. I glued a Chrysnbon soap dish to the shower wall. The blue soap and drain cover are also from ELF Miniatures.
I built a bass wood frame for the shower surround, figuring it out as I went. I painted the wood pieces Warm White by Americana and then installed the shower surround piece by piece. For some pieces, I used double-sided tape as well as glue and pins to keep it all solid and stuck together. I thought tape would be better than glue alone since the tape would stay sticky whereas glue would harden and run the risk of popping loose. It's not the most solid construction, but since it is a stationary unit there shouldn't be a problem with its staying together.
I cut one piece of acrylic sheet to serve as a partial wall and door on the sink side -- I scored a line to delineate where the wall and the door separate. I had originally planned to pin hinge a working door, but the acrylic I had was just too thin to do so without a frame and the idea of a frame didn't match the simple lines I wanted for the shower surround. The hummingbird tile is the focus, and the surround just encloses the unit to make it believable.
I cut small pieces of metal sheet (it has an adhesive back) and stuck them to the acrylic to mimic pin hinge casings. You can't really see them in the photos, but I'll try to get a picture of them once I complete the bathroom. The door handle is from ELF Miniatures. I drilled holes in the acrylic to help keep it attached. And, yes, though it doesn't open, the measurements of the door allow it to clear the wall sink with no problem.
- 2
Recommended Comments
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.